When running an stsadm command I was getting lots of results returned so much so when I scrolled up to the top I couldn’t get to all the results. This is down to the Screen Buffer Size property on the window’s properties. You can change this by following the steps below:
- Open the command line window, if you are doing this in Windows Server 2008 then you may need to run this as an administrator.
- Click n the top level corner and selecting properties from the drop down list
- In the new window select the layout tab
- Increase the Screen Buffer Size limit (This took me a while to get the right figure but you could always bump it up run the command and lower again)
- Click ok
- Re-run your command